Planning：
All projects begin with a planning stage during which light placement and colors are chosen to create the desired effect within whichever environment they are being used. It is advised that this stage be fully completed before beginning any actual installation. Also, be sure to consider how much light a given location receives when choosing where to place lights. They work best when placed under direct sunlight.

Tools required:


Notice to Installer：
No wiring connections.
No transformers present. Our lights do not have an on-off switch since they are triggered by an auto photo sensor. Low voltage,therefore no electrical safety hazards. Listed for wet locations.  Wet location does not imply suitability for installation in applications where fixture is exposed to standing or running water for long periods of time.


Anchorage Installation：
Assemble anchor bolts with bolt template. Place in desired location.
Pour in concrete. Use leveling hardware to adjust to desired finished height after pouring. (Make sure there is at least 2 inches between top of concrete and bolt template.)
Once the concrete has set, remove the bolt template.
Align the anchorage base with the anchor bolts and secure with nut and washer.

Lamp  Installation：
Place the lamp body over the anchorage base.Align anti-theft holes on bollard and anchorage base and secure with anti-theft screws.

Replacing the Battery：
Our solar panel and LED light have an extremely long lifespan so it is only necessary to replace our Lead-Acid battery after 2-3 years. To replace the battery, simply loosen the anti-theft screws on the side of the lamp head securing it to the bollard. Replace the Lead-Acid battery on the bottom of the lamp head. Reassemble by placing the lamp head on lamp pole and securing the anchorage.